We Are Hiring
We Are Moving!

Monthly Archives: December 2020

Start Me Up (Ignition Systems)

When you start up your gasoline engine car, you may not know that it's using the same ignition principles as it has for decades.  You have spark plugs that require enough power so a spark can jump across a gap at its tip.  Years ago, a vehicle's 12-volt system had to produce 15,000-25,000 volts to do that, so engineers came up with something called an ignition coil that bumps up the voltage. It also has to be done at just the right interval called timing. The first systems had a distributor, a mechanical device with a rotating disc that switched the power to the ignition coil on and off.  That higher voltage then was sent to the spark plugs at the correct time interval. But the mechanical "points" had to be replaced and adjusted every 12,000 miles/20,000 kilometers.  Engineers later replaced the switching mechanism with solid state ones, but they still needed replacement after 120,000 miles/200,000 kilometers. The next evolution came in the 80's when the distributor ... read more

The Third Brake Light (Third Brake Light Service)

So you thought you only had two brake lights.  Look again and you'll see one in the center at a higher level than the two on either side of the vehicle.  They're sometimes in the inside of the vehicle behind the back window, or they could be in the deck lid, on the roof or on the spare wheel carrier, But why is that third brake on your vehicle? Experts say it helps prevent rear end collisions. Tests done by installing the third brake light in taxis and fleet vehicles showed fewer rear end crashes in the ones that had the extra light. The third brake light was mandated in new passenger cars in 1986 in the US and Canada.  The requirement was added to new light trucks and vans in 1994. Sometimes it's difficult to know if your third brake light is even working.  Many vehicles have bulb warning systems that alert you to non-functional bulbs, but not all do. Your vehicle service facility will often check to see if all your turn signals, taillights and headlights are worki ... read more

See the Light (Automatic High Beam Dimmers)

It's happened to all of us.  We're driving down a highway at night and over a crest appears a car with its high beams blazing.  You are momentarily blinded, hoping the other driver will switch them to their low beam setting and restore your vision. Not only do we not appreciate being blinded, face it; we don’t want to be that other driver, either.  You know, the one who forgets to turn down their high beams. Why do we want high beams in the first place? They can improve safety when used correctly, giving drivers more reaction time since they can see farther down the road.  But research has found many drivers either don't use them or, when they do, they frequently forget to switch to low beams.  Enter the automatic high-beam dimmer. The quest for the perfect one began back in the 1950s, General Motors invented something it called the "Autronic Eye." It was a phototube which sat on the dashboard and turned down your beams when it saw other headlights.  ... read more

Categories:

Headlamps

Going (Lug) Nuts (Lug Nut Replacement)

Here's a part of your vehicle you probably don't think about much: lug nuts.  They're what fasten your wheels onto your axles.  Pretty important, right? In order to take the wheels off your vehicle to service the brakes, rotate the tires, etc., the lug nuts have to be in good shape so a wrench will grip them tightly.  Because lug nuts are on your wheels, they are exposed to all the elements of the road (salt, water, grime) and really take a beating. Unfortunately, some manufacturers have made them out of two different metals.  Underneath is the working part of the lug nut, made of steel.  On top is the decorative (the "good looking") part, made out of chrome, stainless steel or aluminum.  After a while, the steel part begins to corrode and expands.  That changes the shape of the outer cap, sometimes rounding off the hexagonal edges and making it hard (if not impossible) to either loosen or tighten the lug nuts since the wrench won't fit any more.  ... read more

LightHouse Automotive is committed to ensuring effective communication and digital accessibility to all users. We are continually improving the user experience for everyone, and apply the relevant accessibility standards to achieve these goals. We welcome your feedback. Please call LightHouse Automotive (719) 634-0005 if you have any issues in accessing any area of our website.